Creality SpacePi X4 Riser with Gridfinity Drawers

I wanted some extra storage underneath my Creality SpacePi X4 filament dryer, but nothing appears to be available.

Prerequisite Info:

• This print profile will not work from the Handy app!
• You must first print out and install the mechanical stopper for the cutter arm AND you must setup Bambu Studio to remove the exclusion area of the print bed. This way the pieces that are 254.8 mm in length can print successfully. This also means you must not use your AMS for printing the drawers!

Plates to Print:

1. Required
   1. Riser legs
   2. Riser middle
2. Optional
   1. Drawer Combo 1: Gridfinity top-mid drawer + Large bottom drawer (pictured in my print profile)
   2. Drawer Combo 2: Top-mid drawer + Large bottom drawer
   3. Drawer Combo 3: 2x Gridfinity top-mid drawer + Short bottom drawer
   4. Drawer Combo 4: 2x Top-mid drawer + Short bottom drawer
   5. Drawer Combo 5: Top-mid drawer + Gridfinity top-mid drawer + Short bottom drawer
3. Depending on which drawer combo
   1. If you're printing any combo of top-mid drawer and large bottom drawer: Drawer handles, Drawer rails
   2. If you're printing a short bottom drawer: Short bottom drawer handle, rails
4. Bonus points if you can make the “lol good luck” plate work for you! You'll need to drag drawers these up out of the plate before printing.

The drawers have some resistance when opening and closing them which is something that I'd like to work on revising in a later version.