Ultimate Minimalist Wallet with Buildplate Texture

Assembly instructions below. Now with a1 mini options! I spent months on here downloading wallets trying to find the right on for me. however, many were very bulky or didn't look very stylish that's when I decided to take matters into my own hands. Stylish, sleek, professional and easy to put together. All you will need is a 3d printer, superglue or an adhesive of your choice and m2x8 countersunk for the 5 card wallet and m2x12 countersunk for the 9 card one. you can use standard hex screws they will just rise out of the wallet and wont give a flush look. Please upload pictures of your creations! There are so many customization options with different colors and baseplate designs and I'm exited to see what you all come up with!

Here I will go over assembly steps 1-4 are optional as everything can snap together however will create a stronger bond.

1) Grab superglue and two front pieces of the wallet it will snap into place

2) Put a thin, very small amount of glue over the surface of the wallet. (Little is more, and you don't want it oozing out the sides)

3) Dappen a paper towel corner in glue and run it along the thin bottom edge

4) Connect the two front pieces of the wallet and hold the thin bottom edge together tightly for 30 seconds

5) Connect both lever pieces together through front part of wallet it is a tight fit so will take a little. bit of force. you should hear a little pop when its in. (I like to set the center part of the wallet on the table. put lever on table in-between the center part and use that to set the front plate on to push it through.)

6) Connect front and middle part together with the screws while pushing the parts together tightly

7) Repeat same step as 5 but with back part of wallet