Retroid Pocket 5 Clip Shield Low Profile Case

TL;DR: I recommend printing this vertically and at 100% infill so that the clip on the bottom doesn't snap off 

I'm in love with my Retroid Pocket 5! I wanted to make sure it didn't get scratched up or lose a thumbstick while carrying it around and also have a case that takes up as little room as possible. I couldn't find anything out there so I designed this case with those two factors in mind. 

I hope you like it! 

- Milo :)

This clip shield for the Retroid Pocket 5 was designed to be as low profile as possible while protecting the glass front, buttons, joysticks and triggers.

Features:

• Fully covered screen, buttons and triggers
• Charge port cut out
• Slim, low profile design

Notes:

• To install slide the RP5 in triggers first then clip the bottom of the console into the case.
• For best results print with Matte PLA or Matte PETG