Govee Curtain Light Bracket

Bracket for hanging Govee Curtain Lights H70B1.

If you have the Govee Curtain Lights 2 then use this model - https://makerworld.com/en/models/1848317-govee-curtain-lights-2-bracket

10 brackets are needed to hang each set of lights and they can be extended to support multiple sets. The light spacing is 73mm, but if you have a set where the down strand was attached at significantly less than this, they are designed to scale horizontally. Mine were all 71 - 75 mm and didn't need any scaling.

I used large Command Strips to attach these to my garage door on every other bracket (which is probably excessive). The bracket height is designed to take 2 large command strips vertically if you need for extra strength at the ends. Leave a 1 - 2 mm between each bracket for horizontal thermal expansion, especially if installing a 5 meter (15 ft) length. Failing to do this could cause the center bracket to bow away from the command strips on hot days.

They stay secure when a garage door opens / closes, with the top tab stopping them moving when the garage door is open.

I printed in ASA as my garage door gets a lot of direct sun and it's 80F here, but PLA should be fine in cooler climates. You can get 6 brackets on standard sized Bambu plates. For my 3 sets of Govee lights, my X1C used 500g filament / 14h of print time / 5 plates.

Edit: Now with two choices for the end. A full bracket with no tabs on either the left or right side OR a small plug in reversable cap.