Raspberry Pi 3 Enclosure (Home Assistant / Octoprint)

This is an enclosure I created to house my raspberry Pi 3 that is running Home Assistant. There is no access to the GPIO headers as I do not have any sensors or anything attached.

It is designed to screw the mount onto the wall, then slide the base over the wall mount. Finally press on the enclosure cover and plug in power.

EDIT - 4/23/17 I uploaded a new cover because I discovered a flaw in the export from the original.

EDIT - 11/13/18 I uploaded a cover without the HDMI and audio ports after I had a special request.

NOTE: I do not know what type of screws they are, but I did use screws with a coarse thread and drilled out the holes in my raspberry pi with the same drill bit I use for an M3 screw.