April 22, 2017
Description
I needed a lamp for my soldering table, which is alongside an Ikea Kallax. Unfortunately even hardware stores do seem to have only design in mind, not good lighting. So I defaulted to an old design from the Bauhaus era, shrinked it "a bit" and brought it into 21st century (GU5.3 LED).
For the actual lamp head I borrowed and modified this design:
http://www.thingiverse.com/thing:1305747
The power supply case has a bracket to fit Kallax's side wall and one of the inlays for support. It should stay where it is without additional glueing or screws. Feel free to design a different mount for other furniture.
Apart from the printed parts, the following is needed:
GU5.3 Socket
GU5.3 LED Lamp (max 6W)
6W LED power supply
Power cable
Thin double-wire
M10 threaded pipe (I used 30mms)
M10 Nuts
M10 washer, nylon
M3x10 screws (lots)
M3 nuts
M3x16 screws
M3 Nylock nuts
M3 Winged nuts
2.2mm wood screw
2.9mmx6 wood screws, triangle head
Switch
2 or 2.5mm cable ties
Some super glue
License:
Creative Commons - Attribution - Non-Commercial - Share Alike
rumbero71
