WIP
Printed everything up and it all fits pretty darn well. Won't know for sure until I fit the engine and exhaust. The front bell cranks may also get adjusted if I run into clearance issues with a center driveshaft pillow block on a 4x4 model.
- Rearrangement of the radio gear and steering setup for a Hobby Lobby Hunter.
- Uses stock mounting holes. (at least the holes that were on my test chassis, YMMV)
- Radio box is sized to fit a Tower Hobbies 224 receiver and a 6V receiver battery hump pack. The 5AA NiMH variety in a 2x3 shape. In the pic I'm using a 6AA holder, but i'm going to short one of the battery spaces.
- Radio box lid is held in place with a rubber band.
- still need to add a little bit of wire management for the steering servo. Probably a simple tie down like device.
- The servo saver I'm planning to use is the type that is incorporated into the servo arm horn. Specifically a Kimbrough large servo saver.
Hardware list:
TBD - Various 3mm bolts and nylocks of various sizes
6 3mmID x 3.5mmOD x 5mm long brass tubing to act as bushings for steering arms and drag link.
bummster
