Rc Snowmobile Conversion kit (Polaris Rush)

Update Feb 2020, I added the 1 part sprocket because i was sick of seeing people use the unreliabe 2 part one. I also added the v4 track with the reinforced center seam and the v2 a-arms with the two holes option. Also the wheels were missing apparently. They have being added now.
Hopefully people will appreciate the small touch!

//

These are still the free version 1 files, you can get all the latest files here : www.rccreations.shop/shop

I figures i would upload things to thingiverse instead of my dropbox.

Feel free to share what you make! :)

//

All printed at 0.2 or 0.3 layer height, 6 perimeters, 4 bottom, 5 top layers, 20% infill, 220 Celsius.

//

Here is what you need to know to do the conversion :

Stuff needed in this kit. Yes electronics is one, but you also need some comon hardware like a 3mm rod (allu or brass), a 6mm rod (30mm long), four 1/8 colars, a bunch of screws(M2,M3,M4...) & washers and a bit of glue and finally, a 16 gauge (1.6mm) wire (rust proof), fense wire works great.

The tunnel in made of a thin sheet of steel or aluminium bent and cut. Dimensions in the video

Transmission.
It uses two 6x13x5 bearings, and two (12x18x4) (latest files only). A 56t spur gear and a 14-20t pinion gear from traxxas is used for gears. (look for 56t 32p gear and you should find it...)
Also a few m2 and m3 screws will be needed.

Electronics,
I have in my snowmobile a castle creation Sct brushless combo, a exi steering servo(metal gear) and a spectrum transmitter dx2e and receiver combo. All that coupled to a 3s 2200 mAh from Gens Ace

Shocks, for this kit you are going to need two 60-78mm shocks for the front, one 55-60mm for the middle, and one 70-80 mm for the rear.

//

Here are some of the TOOLS you are going to need to proceed to this operation
-box cutter
-lighter
-screwdriver
-magnet (optionnal)
-pliers
-sheet metal scissors
-a candle
-ruler
-pencil
-drill and drill bits
-vice (optionnal but really helps)
-soldering iron (optionnal)