LapRF 8 Way 3/4" PVC Mount Tiny Whoop Gate

An adjustable mount for the immersionRC LapRF 8-way race timer. This one was designed to be mounted on 3/4" PVC and will need 2 X 25mm 3M screws (hex button top) and two M3 nuts.

There is nothing else needed to mount the timer, the prints should sit on the outsides of the timer just over the rubber feet.

Testing the timer tonight I had my Gain set to 54 and my threshold was set to 1300, but it may require some adjusting for your scenario.

The circle gate is approximately 19" and the Pex tubing I used was cut to 61 inches. The legs are 30 inches tall, and the top piece was cut to fit the circle gate.

The pex coupler was designed to accept 3/4 inch pex tubing.

UPDATE
The V2 version raises the timer closer to the top PVC mounting pole. I had complaints about people getting stuck on top at our local races.