Customizable Whoop Carrying Case

I designed this for my 1S brushless whoop, but this is customizable and can be used with whoops of any size.

It is meant to store the whoop and six batteries.

I used the following parts for my build:

• Beta65 Pro Frame with the low profile mod
• BetaFPV 1S flight controller
• BetaFPV Z02 AIO cam & VTX
• Happymodel SE0802 22000KV motors
• GNB 300mAh 1S HV batteries

The case requires two magnets with a size of 8x3x2mm. But you can adjust the magnet size in the customizer too - you could even use a round magnet by changing the magnetShape parameter

For the hinge I used a piece of 1.75mm filament to connect the two halves of the case.

If you want to customize it for your own model the following settings will be of interest:

• hoopDiameter: The diameter of the hoops
• hoopSpacing: The spacing between the center of the motors, side to side - not diagonal.
• whoopHeight: The height from the table to the top part of the hoops
• whoopHeightTop: The height from the bottom part of the case to the top of the canopy. It is easiest to measure that once the bottom has been printed.

Compatibility (whoop_box)

• BetaFPV Meteor65
• iFlight A65
• 65mm builds based on the BetaFPV Meteor65 Frame
• 65mm builds based on the BetaFPV 65mm Pro Frame

The STL's attached are exports of the default settings. When using the customizer, three files will be generated: one with the top part, one with the bottom part and one with both parts.