DvZ'BRN Take Down Wildcard Magwell for Warburn and Talonclaw

This is a Wildcard Talon/Katana Version of my popular full length takedown magwell for short caliburn variants.
The supplied and altered magrelease works only for talons, but the original wildcard magazine release can be installed.

Use metric/warburn files with metric hardware and Imperial/Talonclaw when working with the locknuts from Slugs hardware kits.

Metric Upper is meant for a 15mm Barrel, Imperial for the 16mm standard sized barrel.

Upper prints upright on front face completely without support. The through-hole for the ram needs to be cleared before assembly and the threaded rods might be tight when screwing them in place for the first time.

The Lower sits flat on its angled bottom face and needs to be printed with support for the front pin holes and - depending on your confidence in your printer - also inside the Plunger Tube Hole.