Nippy - ergonomic stick end for hybrid pinching

As a hybrid pincher, I wanted to get a reliable and reproducible grip on my sticks.
So I made an ergonomic, asymmetric stick end that I will always end up holding the same way.

There are 3 versions of the same model, where only the diameter of the hole on the bottom differs. You get 2mm, 3mm and 4mm holes for use with an M2, M3 or an M4 thread on the radio.

If you print one in a flexible filament like TPU, you would probably want to go 1mm smaller on the hole to get a better grip when screwed on. Other than that, I would actually suggest using a rigid filament like PLA or PETG. I printed mine in XT-CF20.

Before fitting, run a screw in the hole to make a thread of the needed size.

Supports on, 0.2mm layer height or less, 2-3 perimeters, 100% infill.