TwoTrees Sapphire S E3D V6 Hotend and BLTouch Mount

This is still a beta design!
It will most likely change
Two Trees Sapphire S E3d V6 Mount to work with DiiiCooler and bltouch

• has clearance from both sides
• You need to move motor mounts further out (check pictures) with a printed part or something like this: https://www.amazon.com/gp/product/B073QW9RPZ/ref=ppx_yo_dt_b_asin_title_o08_s00?ie=UTF8&psc=1
• no support needed, make sure you place on bed with flat side
• proper airflow from back.
• make sure you have the longer side of the heating block in the back, will barely fit diiicooler.
• diiicooler: https://www.thingiverse.com/thing:1025471 and a 5015 blower fan

Some info on printer:

• I am running Klipper firmware on RPI4
• I use SKR v1.3 32bit board with 2208 stepper drivers
• Capricorn ptfe
• Original E3D Lite
• Non Geared Dual Drive extruder, can easily meet 150mm/s 0.2 layer height limit of V6 without missing any steps: https://www.amazon.com/gp/product/B07WFF3Z77/ref=ppx_yo_dt_b_asin_title_o04_s00?ie=UTF8&psc=1