Source One V3 Street League

Here is what I came up with for a Street League build. It is based off a TBS Source One V3 Dead Cat 7". flip both arms long wise to make it "stretched X". I was able to make weight by printing most parts with 100% infill and a pyro 2200mah 5s battery.

parts and how to print.

Top: the top is designed to hold a nebula pro camera at 45* so most 19mm cameras should work. the antenna mount is made for the small vista antenna. there at pockets to hold a 3mm lock nut to mount it to the frame. (they are fun to get in there so good luck)! I printed it with 100% infill and upright. I used tree supports to support the roof. I added a second top that is for the OG DJI camera.

Bottom front and back. They have a overhang that creates a slot for the wires to run into the frame from your lower leds. there is also a cutout so you can run the battery strap front to back to run the batter toilet tank if you want. I printed these upside down with supports to support the overhang for the led wires.

Session mount. I was able to print this 100% infill on its face with no supports.

Arms. these were designed around the Hyperlite motors but I am sure other motors will fit. there are some holes under the bell for cooling. there is a slot on the top so you can slide these on after every thing is assembled. I put one zip tie at the end closest to the frame to keep them from moving. there are some slots for COB leds on them. the slots already have supports built into them. the only thing that should need supports it the end of the arm that is next to the frame. so if you make your support angle 80* it should just make supports for that part. (I think). I printed these with 3 walls and 10% infill. print two normal and two mirrored.

Battery Box: it should take a pyro or CHNL 2200mah 5s battery. I printed it on its nose with 100% infill and supports just for the nose and the little tabs that go into the frame.

I added a few things.

there are some low profile arms now if you prefer that. but they do not have provisions for LED.

there is a couple main bodies now. one for the OG dji cam and one for a standard 19mm cam with a SMA connector.