April 10, 2023
Description
Umbrella Hanger
This is an Umbrella Hanger which I have created. It has thick joints for strength yet it is still very compact as it is only 120mm wide. It can hold two medium sized umbrellas without any flex and it is very solid. For mounting I used a hammer fixing anchor so that the screw stays in the wall and has added strength. As I mounted mine in the garage it is screwed into brick but I'm sure it is still very strong when crewed into plaster. There are two holes and they are each shaped at a 45 degree angle so that the screw can slot in. It prints in place and I recommend 0.2 layer height, PETG and 60% infill for strength. (0.4mm Nozzle) I would use PETG as I think it is better for this application but PLA should work just as well. The holes are 40mm wide and it allows for the umbrella to slide in and get stuck halfway so that it can hang.
My model on Printables: https://www.printables.com/model/449228-umbrella-hanger
License:
Creative Commons - Attribution - Non-Commercial - No Derivatives
Jakooby
