HeyGears Reflex Bottle Filter Holder

Holds a standard conical paint filter used to strain out resin back into the bottle for regular maintenance. Suggested use is 110-120um(micron) filters. The main idea of this filter holder is that no resin touches the side of the holder, unlike a funnel, and it screws directly onto the bottle. This will eliminate messy funnels, tilting filters, and also you are able to see how much resin is in the bottles through the windows in the holder, so you do not overflow the bottle. For use with HeyGears Reflex 3D Printer. Attached is the ULTx nested with PAU10 material job file for direct upload to the printer. If you are nesting for another material, only support is needed on the bottom edge. You can remove any support that generates on the thread or the upper edge. To reduce the amount of support generated, when using "Auto-Support", set "Overhang Angle" to 15 degrees. I would also suggest setting "Lift Height" to 5mm, and "Tip diameter" to .42mm. Requires no polishing after printing/washing/curing!