Biggs Battle Box - Compact - Stone, Wood, Dragonscale

More compact version of my compact dice boxes.

• No Magnets required for this one.
• The lid slides into the top of the box and is held in place with a friction latch that you have to lift up to release.
• The mini dice tower can be used in the slot it is stored in or outside of the box.
• The peg compartment tapers up for ease of removal.

Comes in three flavors:

• Stone/Brick
• Dragon Scale
• Wood

I have also included three lid designs for each of the boxes:

• Plain
• DND Logo with Border
• DND Logo with fancy border.

I printed the ones pictured at 0.2mm layer height.

Dimensions:

• Overall dimensions are 124mm x 122mm x 37mm

• Dice Box - Has compartments for Dice, MiniFigs, Pegs, and a Dice Tray (small) / Dice tower

   - Dice Box Dimensions: 124mm x 122mm x 37mm
  

Internal dimensions are:
- Dice Compartment - 65mm x 65mm x 35mm
- Dice Tray/Tower Tray - 93mm x 55.5mm x 35mm
- MiniFig Compartment - 65mm x 49mm x 35mm
- Peg Compartment - 50.5mm (Tapers up after 23.5) x 21mm x 35mm

• Dice Tower Dimensions: 88mm x 50mm x 30mm

• Lid/Tracker Dimensions: 121mm x 118.75mm x 6mm

   - Spell Slots - Levels 1 thru 9
   - Death Saves
   - Hit Points - Counters 1 - 999
   - Inspiration - 6 slots for those who use more than one point
   - Misc - 10 slots for tracking things like luck, tokens, etc.
  

• Lid/Logo Printing Instructions:

   - Print the Logo first (It should look upside down and backwards)
   - Center the Logo on the build plate (very important for alignment with lid) - your slicer should have an option to center the object
           - I suggest printing this slowly and do Not used a Brim as you will be leaving it on the build plate, I printed mine at 30mm/s with a Skirt that was removed after printing finished
           - It should only be 1 layer thick if printing at .2mm layer height
  

If printing at .2mm layer height you can turn on Ironing to make sure that the layer looks a bit better
- Leave Logo and border design on the build plate and remove any wipe and/or skirt you have printed
- Print the Lid
- Center the Lid on the build plate (very important for alignment with logo) - your slicer should have an option to center the object
- Print first layer very slowly for Wood Logos or use glue. I printed mine at 15mm/s. I had issues with the sides pealing up that may have just been attributed to the wood filament that I was using